Dual Boot Windows and Linux: Single and Multiple Hard Drives

The Internet is full of articles, how many is too complicated for the average user& 39;s computer is just a simple issue to resolve. If you pay close attention, the Internet is also a place where leaders " & quot; to spend a lot of time yelling for help, discussion boards and forums. So I do not feel bad, and there& 39;s no one answer to everything. I want to dual-boot

so window on the same computer, Linux - it is very, very simple. I only have enough space here, the most common answer is one way to accomplish this task on the hard drive or multiple hard disk drives. Then, obviously, there are many ways to get this job, but there are some important things you should know. Some important information to get started.

windows and Linux: windows operating system on the same hard drive& 39;s master boot record chajihaeya
the (mbr). Linux, on the other hand is not necessary. In this scenario, you must install the windows first! Driver has been successfully installed, and install Linux suit. This is very important! Linux boot loader " & quot; is not going to call it. When you install Linux - Make sure you do not install the Linux boot loader mbr.

configure windows boot loader: 2-step process is also
it dual-booting Windows and Linux can be used only on the same drive, either, but this is a bit more complex - are the windows boot loader will get this job. With the following command to create a copy of the Linux boot sector, and then save the file in the top-level directory window (c:).

step 1: Linux Linux installation shell
from (boot disk to install):
execute following command shell, replacement / dev/hda3 together with the location of your Linux boot partition.

shell dd if = / dev/hda3 = / = 1 count = 512 bachelor bootsect.lnx
- bootsect.lnx -
copy jaebu tingeul new files to a floppy disk and windows.

step 2: windows
copy bootsect.lnx to c: windows. Then, execute the following command from the DOS prompt.

c: > attributes - H - r - so that boot.ini boot.ini

edit seconds, the first and second lines:


timeout = 30 [boot loader]

after to add the final line:

c : = " start bootsect.lnx Linux & quot;

that, and you are done! Tinghago menu appears jaebu computer to Linux or one of the windows you choose to suit. Congratulations.

windows and Linux:
this two hard drives are also very simple. In this case, you drive, the Linux boot. We will add Windows, Linux boot loader (that is, had to guess). My favorite way is not going to the boot loader.

edit / boot / had to guess / grub.conf file. That must include one of the first lines: the last line of

after

timeout = 30 added: Start the

title windows
map (hd1) (hd0)
map
rootnoverify (hd0) (hd1) (hd1, 0) +
makeactive
chainloader 1 drive and

reboot your Linux machine, a menu appears, choose between Linux or windows suit. Nice work!
this does not include documents clearly
short description of how the command works. This pattern, depending on what happens here, I happened to appear on your hardware setup, but I think they are the most common kind, and the gravity of this work. Direct you to other resources siha I do not work for you. 2,005 majella.us
copyright Computer & Technologies.com



Bookmark it: